This isn't directly related to the topic at hand, but is included for completeness. ADC Dynamic Range, Accuracy and Resolution Dynamic Range is defined as ratio between the smallest and the largest signals that can be measured by the system. In SAR images resolution and pixel spacing are two different things. May 20, 2013 #1 Here is a definition of bandwidth that I know: Bandwidth is defined as a band containing all frequencies between upper cut-off and lower cut-off frequencies." screen1988. Bandwidth is the difference between the upper and lower frequencies in a continuous band of frequencies. Resolution means the maximum ability to distinguish two close scatters. Bandwidth, denoted with a W, is the frequency range needed to transmit an analog or digital signal.

Bandwidth and their relationship to Seismic Resolution Tom Wilson, Department of Geology and Geography .

In case of a baseband channel or video signal, the bandwidth is equal to its upper cut-off frequency. Thread starter screen1988; Start date May 20, 2013; Search Forums; New Posts; S. Thread Starter. ADC “Resolution” and “Accuracy”, their relationship to dynamic range, noise floor and implication of these parameters on some of the applications like metering. Joined Mar 7, 2013 310. Bandwidth and frequency both are the measuring terms of networking. Bandwidth B, BW or Δf is the difference between the upper and lower cut-off frequencies of radar receiver, and is typically measured in hertz. It is typically measured in hertz, and depending on context, may specifically refer to passband bandwidth or baseband bandwidth.Passband bandwidth is the difference between the upper and lower cutoff frequencies of, for example, a band-pass filter, a communication channel, or a … Dynamic Range Ratio between the largest and smallest possible values of a changeable quantity. In a Radar receiver the bandwidth is mostly determined by the IF filter stages.

The time taken for the ADC to check and store the amplitude of the echo signal is called the dwell time (D). Sensitivity Ratio of the change ... “SENSITIVITY ” of a lock-in is in fact the upper limit of the measurementrange. Receivers Bandwidth Bandwidth. Let us study the comparison chart of the bandwidth and frequency. Recall our general introduction to the concept of the wavelet earlier in the semester.

2 Tom Wilson, Department of Geology and Geography The range of frequencies present in the wavelet controls its ability to resolve the top and bottom of a layer of given thickness. It is measured as a ratio or as a base -10 or -2.

Bandwidth . During the reception phase the readout gradient receives a range of frequencies and converts it into an MR signal using an analogue digital converter (ADC). The resolution of one SAR image is usually based on the bandwidth of signal (in Range direction) and the 'synthetic bandwidth' in azimuth direction. The basic difference between bandwidth and frequency is that bandwidth measures the amount of data transferred per second whereas the frequency measure the number of oscillation of the data signal per second. The receiver bandwidth is the range of frequencies used during the reception of RF pulses. But I also saw the formula: … For more information about bandwidth, see Signals and Systems or Communication Systems. relation between bandwidth and pulse width.