... A forum community dedicated to all Dodge Dakota and Durango owners and enthusiasts. (Sway bar bushings are shot too.
RE: Torsion Bar Differences IP: Logged Message: That was me. You will only get about 1.5" of lift by doing that. PLEASE click ACCEPT so that I … Unanswered Questions. Subject: Torsion bar Lift IP: Logged Message: How hard is it to do a torsion bar lift.
the torsion bar all the way through to remove it. This durable, solid-steel tool makes it easy to load and unload torsion keys without damaging the torsion bar or your hands! Im trying to figgure out how exactly im going to get the torsion bar off without killing myself. (2) Turn the adjustment bolt counterclockwise to release spring load (Fig. if your re using them then don't knick the bars and use the removal tool or something similar, if not using the bars over you can just stick a set of vice grips or something on them and bang the bars out. Here is Dodge procedures . I've been banging on it and spraying it with WD40 and even some Deep Creep and it's …
99 4x4 95,000 miles. 3) Remove the adjustment bolt from swivel. The big difference is the fact that the durango was MUCH heavier than even a fully loaded quad cab, thus the need for bigger t-bars. torsion bar adjuster bolts. 5). (4) Remove torsion bar and anchor. I'm replacing my upper and lower control arms as well on my '01 4x4 Dakota. I got the upper control arm replaced and I have the lower removed, but the lower control arm still has the torsion bar stuck in it. i sprayed white grease on the ends, still makes noise. What are the advantage and disadvantage of orthopneic position. TORSION BAR . REMOVAL (1) Raise and support the vehicle with the front suspension hanging.
3) remove torsion bar retaining clip at rear of bar 4) slide the torsion bar out the rear of the cross member. Remove anchor from torsion bar. From: Message: Lucas Dodge Dakota JOIN HERE 2/28/2006 13:47:50: Subject: Torsion Bars IP: Logged Message: They are making a metal on metal noise. could be tough. click link below . now, if somebody could do a coilover/coil spring swap, and document it on here, I'd love them forever.
1999 dodge dakota 4x4 v8. In theory, the torsion bars should swap over with the torsion bar mounts and the lower control arms from said Durango. Started taking the front end apart on the 04 4x4 to replace the lower ball joints and inner tierod ends. Unload your torsion bars fast, safely, and effectively with Rough Country’s Torsion Bar Removal Tool.
Copyright 2020 dodge dakota torsion bar removal